Car stereo installation is not at all easy or inexpensive. Sometimes it may be so expensive you may have to do it yourself if you have a tight budget. But if you were an inexperienced person, no matter how good and expensive your car stereo system may be, it would not be able to produce quality sound. Therefore, for better sound effect in your car you need to know how to install a car stereo. Installing of a new car stereo in the car will be extremely easy for anyone with any experience in wiring. But you need not worry. Even if you do not know anything about wiring, the following points will show you how to install a car stereo system yourself.
Before you install your car stereo there are a few things you need to keep in hand, which include wire cutters, electrical tape, screwdriver set, wire strippers and of course the new car stereo. Here are some tips on how to install a car stereo perfectly so that it will produce better sound effects.
Buy a new car stereo keeping in mind what you need and what will fit into the slot provided in your car. When you get a new car stereo system you may also get a wiring harness, which is specific to both your car and to the new car stereo. This will be an added advantage and can make the wiring job much easier. If you are unable to obtain a wiring harness connect each wire yourself. There will be a guidebook to direct you how to connect.
Plug in the wiring harness to the back of your new car stereo. Connect the positive and the negative wire from each speaker to the positive and negative connector respectively on the back of your stereo first. Make sure it is connected properly because if it is not, the speakers will not function at all. Now connect the ground wire, usually the black wire, of the stereo to a screw or a bolt located near the dash where the car stereo is mounted. But make sure the wire attachment is done to a metal and not to plastic or fiberglass.
Connect the 12 constant and ignition power wires to the stereo. You can refer to the installation instructions to make sure all the wires go to the correct places. Slide your car stereo into the mounting bracket that came with your stereo. After you have plugged the harness or the wires slide it into the slot in the dash. Do not screw it yet as you will need to test it first. You will find one wire connector option at the back of your stereo that is the option for the antenna.
After you have performed all the above tips, connect the negative cable of your car to the battery. Then turn on your car and the power of your car stereo. Put some music and listen to all your speakers and make sure everything works. Then you can screw your car stereo into the dash. |
![[Valid RSS feed]](/images/icon_Rss.png "The Author : XML Feed For RSS"){kind=icon}
Print This Article
Add To Favorites
Html & Info
Post a Comment
